It’s that time once again that we’re going to doing another minecraft challenge this time I’m going to take on one of the most frequently challenged minecraft challenges that has been popping up down the comment section you guys have been asking me to build a cubic piston door now this is I mean I’ve never even thought about doing something like this before so my initial idea is is to kind of create almost like a hipster door layout but obviously make it two blocks thicker so we’re going to have Pistons on either side just like this those are going to Be grabbing the bottom blocks and then to actually power this entire thing we’re going to need a triple piston extender which is going to be running up like this so that’s going to be going up to about there and that will be grabbing the top blocks all right I mean it seems Possible I think we could be able to do it let’s see so let’s do a quick dry run of one of the sections so be that and then it will be that so that we would track that then this and then this and then matrac that and then it’ll be the Full triple piston extension which goes up something a little bit like that and then we gradually make our way down oh but we do have an issue there huh I really want to use an observer here but I cannot for the life of me make it function properly the idea is is that This observer right here gets updated by this dropper as this redstone powers but this redstone powering also updates this sticky piston to tell it hey this block has been powered and then it will quickly extend and retract but that’s it’s not functioning that was the plan okay it’s not working unless I do Something a little bit like this it’s gonna be super fast so prepare yourselves what you do is repower this one and then that will do that and then we need to make sure that we retract that block all the way down and then retract it across to reveal the piston Extender once again then we need to do the full triple extension which looks something it a little bit like that and then we can pull all of that down pull this one one block further down and then extend this back across and that’s everything open for one quarter of the Door still haven’t worked out the closing yet though which does not seem too in this setup hmm I’m I’m lost but now I’ve kind of whiteout a little bit I mean it was a little bit shaky but I think we’re going to be able to pull it Off so I’ve removed all of the levers and I’ve started working on some of the circuitry and this right here is probably one of the most well probably one of the largest double piston extenders I’ve ever created but it is working and it pulls the bottom block Down and then moves out of the way to make way for the triple piston extender circuit which is going to be launching up from the bottom now the way the lawyer actually managed to pull this off it’s pretty interesting but there is a slight issue there we’re not going to be Able to power that block hmm let’s see how this is doing then so I’ve added in some extra circuitry which is going to kick-start the trip with an extender and if we give this a flick that kicks in good that was a tiny bit mess I can’t Work out what was too early then if it was too early or too late let’s see so if we flick it I think it was too late oh yeah it was too late so there we go there was the two ticks I literally just put in and that works okay that was Unexpected so now it’s just a case of bringing that home and then bringing that one down and then shooting this one back across things are going well but we aren’t without problems I’ve had to redesign all of this circuitry right here because I was relying on a redstone Dots which of course we’re not going to have when we add in the other three quarters so that’s now been replaced for the repeater and also I’ve added in all the circuitry down at the bottom and you can see that we really are getting there now everything moves out the way Everything gets retracted downwards and this piston is all that’s left to move out the way that one right there and this could just be the last test of the opening sequence so let’s give it a whirl I’ve kind of got high hopes but also not that high oh that was close We need a little bit more delay I think this could be it so sticky piston zesty Pistons they’re all good or good and then our blocks everything is in order right this is the one I can feel it my bones here we go why did he do that but Now despite size increases we have fixed that little pop-up issue and it is done that was it okay now time for the closing let’s see if we can even do this with levers I kind of remember how I was planning on doing it and now I’ve remembered and I’ve Remembered that actually it’s going to be very simple I I imagine it’s going to be very similar probably shouldn’t say words like that because I always end up eating my own words when I say things are going to be super simple but in theory if I just put say for example Like a sword inside this dropper to increase the signal strength so then it stretches out to both of these okay nope nope I knew it yeah no symbol at all because I have connected this circuit which is the circuit the powers are bottom piston into a whole bunch of other things it Links off from there which means that if I power the bottom piston it also activates all of this top section of the circuitry I don’t I just don’t think ahead sometimes and I’m doing these redstone lights this is so embarrassing I’ve had to redo pretty much all the Circuitry I can’t believe I said I never ever say this is really simple in any of my redstone videos especially if I haven’t built it yet that’s a terrible terrible idea today I decided to do it and as I say I’ve rewired all of this bottom area here we’ve got completely New pathways full of the redstone and everything and it still doesn’t quite work nope let’s see okay let’s just try properly here goes yeah it’s just too fast ah yes that worked it actually functions look that is so uninteresting and so unexcited but that’s what we need to Happen to push these blogs back up oh my what I think might have just done it now what we need to do is create a falling edge mana stable circuit for this one which shouldn’t be too difficult and that’s just going to run the input out Round like this and into the side of this block idly again I said the words shouldn’t be too difficult it was difficult so we’ve had to rewire I just have once again but now we’re back and I believe this thing should now be functioning if I just put in a redstone Torch there real quick that is the pushing mechanism and then we can flick this and that will do the full opening there we go there it is 1/4 of the door has opened up and then when we flick the lever once again 1/4 has been pushed Back up our cube has returned ok time to actually make this entire cube open there is a middle to high likelihood that this thing is going to completely fold in on itself and destroy itself yeah that’s exactly what it did I wonder what caused that absolutely no clue Let’s see if at least the closing works well that’s good that’s promising I don’t know what on earth is happening with the opening then Oh with that quite glaring issue fixed I imagine it is now all working oh we were so close we were so close nothing is coming to mind nothing seems To be functioning properly I cannot seem to work out one earth is causing these issues and it’s driving me round the bend it’s certainly rather penned a seriously long time has passed since the previous clip I have done a lot of things deconstructed this thing redesigned a bunch of bits and pieces I’ve split up into different quarters I’ve tested those individually I’ve tested in half since they’re everything it’s nothing was working but I think I might have finally found the culprit here as you can see we’ve got this pulse extender that is in this area and it gets powered by this repeater and also Gets powered from this side as well but one thing that’s not meant apparent is this block right here this block right here isn’t meant to power this pulse extender however it does when we build the other half this block sits next to this redstone line which means that now We have what we have a new pulse coming in from nowhere which is messing with the timings at the bottom circuitry I really hope I really hope that that’s it and we can actually find a fix for this so here goes this is it final test I imagine I hope Fingers crossed and everything like that so there is the closing we’ve all seen that one before and here comes the opening we actually did it it is finished Oh words this has been many hours in the making but there it is one cube door now I am going to I’m Going to make this Mordor like very good very good totally an utterly pointless absolutely pointless pointless redstone contraption but you guys have been asking for it a ton down in the comment section so here it is this is my 2×2 cubed or or 2 by 2 By 2 cube door now before I go I just want to issue you a bit of a challenge there’s two challenges actually number one that this door is absolutely massive as you can see the redstone circuitry is huge I think you guys should be able to Compact it so there’s a bit of a challenge for you and number two and this this is one that I don’t actually know if it’s possible or not it would be cool if there was a three by three by three cubed or as I say I have no curve As possible I tried some piston layouts earlier on and concluded that I personally wouldn’t be able to do it but you guys are considerably smarter than me so far away I’d love to see your responses to it and please do send your designs to me via Twitter I cannot wait To see what you guys come up with but unfortunately ladies and gentlemen that is all I’ve got time for today I hope you enjoyed this video if you did visual to that like button and if you really loved it then make sure to subscribe but thanks for watching guys This is remembe oh and I’m out I’ll see you later oh and as for usual check out the latest film on the filming channel one literally just released the other day it’s really quite good I enjoyed making it and I’m sure you’ll love You Video Information
This video, titled ‘MINECRAFT CHALLENGE: The CUBE DOOR!’, was uploaded by Mumbo Jumbo on 2017-11-14 20:00:02. It has garnered 553396 views and 14710 likes. The duration of the video is 00:11:46 or 706 seconds.
Leave a LIKE if you enjoyed this redstone video! Today we take a look at the cube piston door.. A door that is cube shaped. This was one heck of a challenge, but I managed to just about pull it off!
The Mumbo Merch Store! It’s beautiful! http://www.awin1.com/cread.php?awinmid=2549&awinaffid=402161&clickref=Mumbo+Link&p=https%3A%2F%2Fus.zavvi.com%2Fyour-store%2Fthat-mumbo-jumbo.list
Become a Patron for a spot on the Patreon Server! https://www.patreon.com/ThatMumboJumbo
My INSANE PC was kindly provided by Chillblast, a company specialising in Performance systems. We have a full range available with 3 systems of varying price and power! Check them out here: www.chillblast.com/mumbojumbo
My server is kindly provide by CubedHost free of charge! Click this link to get a 25% discount off one of their servers! http://cubedhost.com/thatmumbojumbo
2ND CHANNEL: https://www.youtube.com/thatmumbojumbo2 TWITTER: https://twitter.com/ThatMumboJumbo INSTAGRAM: http://instagram.com/officialmumbo OFFICIAL MUMBO JUMBO PCS: https://www.chillblast.com/mumbo-jumbo-official-computers.html
————————————————-
My texture pack is Faithful and Codecrafted combined. Faithful: http://www.minecraftforum.net/forums/mapping-and-modding/resource-packs/1223254-faithful-32×32-pack-update-load-of-new-ctm-1-7 CodeCrafted: https://www.youtube.com/watch?v=TL2IKidhWb4
Intro: ProleteR – Can’t Stop Me outro: ProleteR – April Showers http://www.youtube.com/user/proleterbeats https://www.facebook.com/ProleteR.beats http://proleter.bandcamp.com/
Timelapse: LAKEY INSPIRED https://soundcloud.com/lakeyinspired
Upload Schedule:
Tuesday – Redstone Wednesday – Hermitcraft Thursday – Redstone Friday – Hermitcraft Saturday – Redstone Sunday – Hermitcraft