Automating Crystal Production in Minecraft with AppliedEnergistics Mod
In this Minecraft guide, you will learn how to automate the production of crystals using the AppliedEnergistics mod. By following these steps, you can streamline your crystal production process and save time in your gameplay.
Finding a Meteorite
To begin, you will need to find a meteorite. Use a meteorite compass to locate one. Once you have found a meteorite, you can start excavating it. Inside the meteorite, you will find presses, crystals, and flowering blocks.
Setting Up the ME System
Next, you will need to set up a standard ME system. Start by taking the cables from the controller and installing them. Then, install the interface and connect the export bus. Place the cracked flowering stone on top and add the quartz fiber. On top of the fiber, place a barrel and connect it to the import bus.
Install storage buses on the top and side of the barrel, and connect the cable from the interface to the bus. Use fiber and cables of a different color for this step. In the storage bus on the side, install a block of true quartz, and place crystals of true quartz in the tire above the barrel.
Automating Crystal Growth
Now, let’s automate the crystal growth process. Start by placing crystal growth accelerators. Below them, place a formation plane and install a cracked flowering block in it. Opposite the flowering block, place a plane of destruction with a silk touch. On top, place another plane of destruction.
If you want to increase your chances of getting better drops, you can enchant the plane of destruction through an anvil. To replenish the flowering block, you will need to make another circuit. Install the production storage and use a template with the desired craft.
Take the cables away from the controller again and install the template supplier and the interface. Install quartz fiber along the edges and connect the storage bus and the interface. Place a cracked flowering block in the storage bus. Use blue cables to extend the connection.
Put facades on the side and place the destruction plane. Close it with blocks to prevent water from flowing out. Finally, set the formation plane and switch the installation mode. Pour water and set the necessary template.
Conclusion
By following these steps, you can automate the production of crystals in Minecraft using the AppliedEnergistics mod. This will save you time and effort, allowing you to focus on other aspects of the game. If you found this guide helpful, let us know in the comments. And don’t forget to check out our servers for more Minecraft fun!